my technical blogger Business

How To Use Ali 3510d And Ali 3510c Processors receiver

71 / 100

How to use Ali 3510d and Ali 3510c processors 

Hello, my brothers. Today I will share with you a receiver user, the processor on 3510c, the processor on 3510d, the processor on 3510e, the processor on 3510g, and the processor on 3510a. But before I share your loader tool, you need to know your loader tool. 
What is a loader and how do you use it? Sometimes, during software upgrades or repairs due to a software bug or other error, our receiver device becomes dead or stuck at the red lamp. 
So, in this case, we have two ways to restore and repair our receiver.
We can restore the software using the loader tool, and the second option we have is to charge the Bios flashing programmer, which is mostly available in the programmer. 
But in this post, I will discuss the loader tool.
A loader is a computer program that every manufacturer of satellite receivers provides for its users to use in the event of any damage or loss. To recover our receiver, we need three basic things.
(1) a computer. 
(2) RS232 cables for 
(3) Download tool. 
We hope you know something about computers or laptops, so I don’t need further discussion about computers.
What is an RS232 cable? To put the software in our box, we need three main connections: RX, TX, and  GND  from receiver to computer or cable.
Therefore, we need to connect to our computer or laptop, STB, or receiver.
In this case, we need a specific cable called the Rs232, or DB9 cable.
You can buy an Rs232 cable at any local electronic market or from any satellite dish mechanic store. You can also buy it from any online store.
Rs232 cable for laptop users.
are on your cables. If you are a laptop user and want to use all this process on your laptop, then you need to buy two cables. One is an Rs232 to USB male cable; the second is an Rs232 female-to-female cable. 
These two cables are not very expensive.
And you can buy it easily from any online marketplace or online store.
But it should be noted that we need to upload the software to the receiver through Ch341 or Ch340 IC, so when purchasing an Rs232 USB cable, you have to ask the shopkeeper to give you an Rs232 USB cable with Ch340 or Ch341 supported IC. Otherwise, the loader will not operate.
Rs232 cable for computer/computer users. If you have a computer or a computer and want to use the download tool on it, then you have to buy one simple RS232 female-to-female cable. And you can do the whole process with this single cable.
RS232 cable and mini jacket. To do all these operations, our receiver must have a jacket or an Rs232 port. So, nowadays, the receiver mostly comes without an external RS232 port. 
In this case, we need to insert another Mini Rs232 cable into our receiver. 
You can also take this mini Rs232 cable from any satellite receiver mechanical store, or you can also remove it from any other old receiver.
When you have arranged all of the above things according to your requirements, then you then need an uploader for your satellite receiver processor.
There are many satellite receiver manufacturers with different processors. But in this post, I am going to share with you my processor loader. You can use the following bearings for the following board panels:


Here are all the loaders.

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More